Foruzan Ahmadi; Kazem Nosrati; Mohamad Mehdi Hoseinzadeh
Volume 6, Issue 20 , December 2019, , Pages 141-164
Abstract
1-IntroductionAccelerated soil erosion is a serious problem in Iran, leading to degradation of soil and water resources, reduction of soil fertility, destruction of range and agricultural lands, desertification, recurring floods, sedimentation of reservoirs, and pollution of fishery habitats. Hence, ...
Read More
1-IntroductionAccelerated soil erosion is a serious problem in Iran, leading to degradation of soil and water resources, reduction of soil fertility, destruction of range and agricultural lands, desertification, recurring floods, sedimentation of reservoirs, and pollution of fishery habitats. Hence, understanding of the potential soil erosion process and opposition to this erosion are necessary environmental. To this end, uptake and refinement of sediment source tracing or fingerprinting techniques has expanded dramatically as an alternative approach to traditional methods of identifying key sediment sources. Sediment source fingerprinting involves discriminating potential sediment sources on the basis of differences in source material properties or tracers and determining the relative contributions of these sources to sampled target sediment. different kinds of sediment sources have been used so far in sediment fingerprinting techniques (e. g., land use, geology, sub-basins, surface and subsurface erosion) but, there is a little attention paid to the selecting the soil erodibility groups as sediment sources. Therefore, the main objective of this study are the Kouhdasht watershed dividing into different erodible units based on soil erodibility index and determination of the contribution of each unit in sediment yield using an un-mixing Bayesian uncertainty model and to find its relationship with soil organic carbon stock. 2- MethodologyKouhdasht basin with 1138 km2 area located in 33° 17´ to 33° 41´ north latitude and 47° 20´ to 47° 50´ eastern longitude in western of Lorestan province. samples were collected in two stages; first, 81 samples in order to estimate erodibility, second, in order to determine the contribution of each source to sediment yield, 70 soil samples were collected form sources and 12 sediment samples collected at the basin outlet. The soil erodibility was calculated based on the soil texture and based on the geometric mean of the soil particle diameter. Based on the amount of soil erodibility, the area was divided into three different erosion units as sediment sources. To determine the contribution of sediment sources to sediment yield used fingerprinting technique is based on estimation of uncertainty.3- ResultsThe erodibility of the study area varied from 0.0386 to 0.0663. Erodible units were identified as sediment sources based on the values obtained from the erosion parameter and according to the results of selecting the optimal combination of tracers. The results showed that the first erosion unit 2%, the second erodible unit 5%, and the third erosion unit 93% contributed in the region's sediment yield. The relative importance of erodible units in sediment yield was obtained by dividing the share of each resource in the production of sediment into the percentage covered by each source. The relative importance of the first, second and third erosion units is 0.08, 0.28, and 1.57, respectively. Regarding the role of organic carbon in erosion, the amount of organic carbon storage in different erosion units of the area was also measured. The amount of organic carbon storage in each erosion unit is first, second and third ones were 70.5, 64.3 and 54.6 mg / ha respectively. 4- Discussion and conclusionThe third unit with 93% has the largest contribution in sediment yield and with 54.6 mg / ha, it has the lowest amount of organic carbon storage in the area. Considering that this unit is most used in agriculture and geologically under quaternary sediments, showed that the parts that are under cultivation and quaternary sediments have both high erodibility and the highest contribution to sediment yield. Measurements of organic carbon storage also showed, there is the least amount of organic carbon storage in this unit and this suggests that in the third unit, the damage caused by the loss of fine sediments such as clay is higher. Given that the third unit is under agricultural use this can be attributed to the type of land use and exploitation. Therefore recommended more attention to the type of use of land and soil management and conservation programs implemented in the region.
Saeed Jahanbakhsh Asl; Alimohammad Khorshiddoust; Mohammad Hossein Alinejad; Farnaz Pourasghr
Volume 3, Issue 7 , October 2016, , Pages 107-122
Abstract
Saeed Jahanbakhsh Asl[1]* Alimohammad Khorshidoust [2] Mohammad Hossein Aalinejad[3] Farnaz Pourasghar[4] Abstract Temperature and precipitation are two important parameters in hydrology and water resources. The impact of climate change on these two parameters has been the subject of many studies and ...
Read More
Saeed Jahanbakhsh Asl[1]* Alimohammad Khorshidoust [2] Mohammad Hossein Aalinejad[3] Farnaz Pourasghar[4] Abstract Temperature and precipitation are two important parameters in hydrology and water resources. The impact of climate change on these two parameters has been the subject of many studies and studying atmospheric general circulation models is one of the best methods to estimate its effects. In the studies of climate change, lack of uncertainty in various stages of evaluation for the effect of climate change reduce certainty and confidence of the final outputs. In this study for analyzing the effects of climate change on precipitation and temperature in Shahrchay basin and the effects of the uncertainty related to general circulation models, six atmospheric general circulation model and 3 scenarios, A1B, A2 and B1 were downscaled by using LARS-WG. For evaluating the uncertainty of the models and scenarios, the output of models in the future and based period were compared by monthly statistical indices, coefficient of determination (R2) and Root Mean Square Error (RMSE) and the best models and scenarios for producing temperature and precipitation data were selected for the period 2011-2030. As the results, the HADCM3 model under scenarios A1B was used for precipitation and the MPEH5 under scenarios A2 for temperature production. The results of this research showed that in the future period rainfall will be reduced about 9 millimeter, while the minimum and maximum temperature will increase 1.05 and 0.87 °C respectively. Disruptions of rainfall distribution and high temperature have significantly negative consequences than rainfall reduction. [1]- Professor in Department of Meteorological, University of Tabriz, (Corresponding Autor), Email:s_jahan@tabrizu.ac.ir. [2]- Professor in Department of Meteorological, University of Tabriz. [3]- Meteorological Graduate Student of Tabriz Universit, Email:aalineghad63@yahoo.com. [4]- Climatology Ph.D., Meteorology Directorate General of East Azerbaijan Province.
